Aluminium Alloy 6082 Data Sheet - thyssenkrupp Materials
In the T6 and T651 temper, 6082 machines well and produces tight coils of swarf when chip breakers
We are more than an aluminium alloy solution provider.
Do you need consumer aluminium alloy products or learn more info about aluminum alloy prices?
In the T6 and T651 temper, 6082 machines well and produces tight coils of swarf when chip breakers
Alloy 6082 T6 amp; T651 is typically supplied as Plate and Shate. • Plate • Sheet GENERIC PHYSICAL
6082 ： T6 - O - T4 -
6082-T651 Aluminum. 6082-T651 aluminum is 6082 aluminum in the T651
Both 6082-T6 aluminum and 6082-T651 aluminum are variants of the same material.
6061T6T651. ，， 6061-T6T651 。. T6T651，T6，，
T651 is the temper of Aluminum 6082, is achieved by heat-treating, stress relieving and artificially
1: T6T651，T651
6061 ，6XXX 。 ，。 。 ， 6061-O, 6061-T4, 6061-T6, 6061-T651, 6061-T42 。 1 1.1 2 2.1 6061-0 2.2 6061-T4 2.3 6061-T 3.1 3.2 4 5
Aluminium alloy 6082 is a medium strength alloy with excellent corrosion resistance. It has the highest strength of the 6000 series alloys. Alloy 6082 is known as a structural alloy. In plate form, 6082 is the alloy most commonly used for
In the T6 and T651 temper, Aluminium alloy 6082 machines well and produces tight coils of swarf when chip breakers are used. Chemical Composition of Aluminium alloy 6082 Table 1. Chemical composition for aluminium alloy 6082 Properties of Aluminium alloy 6082 Mechanical Properties of Aluminium alloy 6082 Table 2
Scope. Aluminium 6082 is a medium strength alloy with excellent corrosion resistance. It has the highest strength of 6000 series alloys. Alloy 6082 is known as a structural alloy. In plate form, 6082 is the alloy most commonly used for machining. As a relatively new alloy, the higher strength of 6082 has seen it replace 6061 in many
6082-T651 Aluminum 6082-T651 aluminum is 6082 aluminum in the T651 temper. To achieve this temper, the metal is solution heat-treated, stress relieved, then artificially aged. The stress relief is accomplished by stretching the metal by an amount that depends on the type of standard wrought product being made (sheet, plate, bar, or
This is the largest WN diameter that has been obtained experimentally under optimal welding parameters for AL-6082-T651 for both the joints. For stress analysis one end of the joint is applied with a force of 6 KN for RSW joint and 35 KN for WB joint, while the other end is kept
247 1． ，。 ，6061-T67075-T651。 ，，，，，，，。 ，6061－T67075－T651，
--, 、 ， 、 。 6082 HBS ≥80；6061≥95。 、、 、、、、。 ， 6082。 6082 （